11 Comments

  • Kenny Mozingo
    Posted May 29, 2020 2:37 pm 0Likes

    Can I use my oe steering wheel control or do I have to swap out with yours?

    • shanshanli
      Posted June 15, 2020 2:24 pm 0Likes

      Yes, if your Jeep button has 6 little buttons, you can keep it,

  • kenny mozingo
    Posted May 29, 2020 9:27 pm 0Likes

    just got my jpro do i have to sync it before you can give me activation code?

    • shanshanli
      Posted June 15, 2020 2:22 pm 0Likes

      Yes, need active code to sync the data

  • Julius
    Posted August 15, 2020 11:40 am 0Likes

    I have a 2018 Jku with
    Alpine X409-WRA-J

    I also have the edelbrock supercharger

    How will your jpro work with both of these?

    • carobotor
      Posted August 18, 2020 11:57 am 0Likes

      Hi,it can work together with them,

  • Chris
    Posted October 9, 2020 2:41 am 0Likes

    Just installed dash in my 2014 rubicon and the bar/psi pressure is not showing. It just shows zero.

    • carobotor
      Posted October 29, 2020 12:58 pm 0Likes

      It will show after you drive it.

  • Shankar
    Posted October 26, 2020 1:23 pm 0Likes

    I had a flat battery for a week. After battery charged fully, only fuel gauge, oil temperature gauge and top row display icons are working.
    Main display is off.
    Any remedy?

    • carobotor
      Posted October 29, 2020 12:56 pm 0Likes

      You can start your engine and charge the J Pro around 5 mins, then it will work again.

    • carobotor
      Posted November 12, 2020 5:27 pm 0Likes

      You can start your car for a few mins then the J Pro can work again.

Leave a comment

I accept the Privacy Policy